I now have one more question. This site is intended for reference only. This site is just a collection of experiences with our vehicles. Thanks in advance to all! This explains why there is no oil level check. G 1410- 4…20 Nm Hose clamps, up to 25 mm -3094-. I now have one more question. Nor did the article I found on this site.
If you squeezed the bottle, fluid leaked out the vent. Your mileage may vary, and all info is provided as is. Is the tube a single piece or at least connected to form a single channel? Turn stopcock and put the fluid in. But you can just use a funnel in the filter housing to slowly add the fluid from the top. I have a Bentley manual, and it doesn't metion anything about that.
Fluid level procedure requires action at 35°-45°C, which is tranny fluid temp, not engine. Took me a few hours to do. It's made of , it has passed not only all manufacturer's tests but also Volkswagen Group quality control and has to endure rough road conditions over a long time. Get the trans up to temp then drain excess fluid I've done it, and I can't imagine ever wanting to spend the money to buy or build one of these. Pass tube over transmission to battery area.
I just ordered it along with the fluid and filter. It looks like they added a couple of vent tubes to speed up adding fluid. Why do I have to cut the pipe in order to fit it into the bottle? Therefore, there is no need to check the oil level of this gearbox. You won't be able to buy these tools at the dealer. I have a Bentley manual, and it doesn't metion anything about that. There's plenty of tutorials and videos that show how to do it.
Screw the obvious part on the bottle. It looks like it would work like this: Attach adapter. Clean area around breather hole with a cloth and fit the breather cap. It fits for Volkswagen Group vehicles which were sold in the U. All trademarks and copyrights on this page are owned by their respective owners.
It just looks like the tube allows air into the oil bottle. I see no way to seal it off while filling. I like to know what this tool is design to to work with? The actual service isn't too hard. Did the service in a few hours. Do these brass tubes go up in the transmission, and if so, will fluid not flow out the drain valve? Other materials: Special tools and workshop equipment required Torque wrench -V.
Want something added to the sidebar? Shake oil bottles before filling. Aero-Clean neutralises microbes and bacteria in the heater and air conditioner unit. . Photos, stories, information or other material may not be copied, reprinted or reproduced without written permission. Screw the obvious part on the bottle. I found all the stuff at my local hardware store. Please contact your local dealer for latest info.
It looks like they added a couple of vent tubes to speed up adding fluid. Turn stopcock and put the fluid in. The tool worked like a charm. Attach oil bottle and turn the whole mess upside-down. Seems you could let it run until it heats up and then drain the excess. Special tools and workshop equipment required Counterhold -3067- Removing Gearbox removed.
The new oil is poured in through the breather hole. Capacities Capacities after draining oil for general repair work 1. Pictures here: Using either method, the rest of the steps are the same. Please help our community —. Feel free to contact us if you have any questions:.